Kirkwood HVAC & Plumbing Services

Installed a 50-gallon State ProLine natural gas tall water heater in basement utility area. Connected copper supply lines and gas piping to new unit, established proper venting, and verified all connections for code compliance. Obtained City of Kirkwood plumbing permit (PLUM-26-0507) for installation, confirmed unit meets ANSI Z21.10.1-2011 standards, and completed all required safety checks prior to commissioning the water heater for operation.

Completed comprehensive cooling season tune-up on 3-year-old outdoor condensing unit. Performed full system inspection including amperage draw verification using clamp meter (reading 9.82A), accessed and inspected condenser coil condition through side panel, and evaluated fan motor operation. All components found operating within normal parameters with no deficiencies noted.

Responded to service call for rattling noise coming from 10-year-old basement air conditioning unit. Upon arrival, inspected outdoor condenser unit and found heavy accumulation of dirt and debris on front panel and internal components. Removed access panel and thoroughly cleaned condenser coils, fan assembly, and housing. Identified loose mounting hardware on blower fan causing vibration and rattling noise audible through ductwork. Tightened all fasteners and secured fan assembly. Cycled system through multiple operation cycles to verify elimination of rattling noise. Unit operating properly with normal airflow and cooling capacity restored.

Responded to water leak complaint from 10-year-old air conditioning unit located in garage. Upon arrival, performed system inspection and temperature diagnostics on supply ductwork, recording readings of 78.8°F and 73°F at various points along the metal duct assembly. Identified source of moisture concern and assessed overall system operation to determine appropriate corrective action.

Completed comprehensive cooling tune-up on 3-year-old residential AC system. Condenser coils were heavily clogged with dust, dirt, and debris accumulation, significantly restricting airflow through the unit. Thoroughly cleaned and cleared all exterior coil surfaces, restoring proper ventilation and heat exchange efficiency to manufacturer specifications.

Responded to no cooling complaint on residential HVAC system less than 10 years old. Customer reported unit cycling off frequently and failing to maintain setpoint temperature. Upon arrival, advised customer to power down system for safety. Performed diagnostic inspection of air handler unit, accessing interior cabinet to examine electrical components and blower assembly. Inspected circuit breaker panel, control wiring, and blower motor (TEEMAR2C3415CA). Documented system conditions with photos for service records.

Responded to no cooling complaint on 10+ year old residential air conditioning system located on side of home. Upon arrival, performed diagnostic evaluation of HVAC unit and air handler. Inspected system components, checked refrigerant pressures, and assessed overall equipment operation. System evaluated and findings documented with photos of equipment and installation area.

Completed comprehensive cooling system tune-up on a 2-year-old residential AC unit located on side of property. Performed full system inspection, replaced air filter, verified refrigerant levels, checked electrical connections, and confirmed optimal operating performance. Unit is functioning efficiently with no issues identified.

Responded to geothermal system experiencing low refrigerant levels with air handler located in attic. Upon inspection, identified refrigerant loss in the system and documented existing equipment conditions including copper refrigerant lines, valves, and associated mechanical components in the utility area. Noted previous equipment failure documentation marked on system components.

Installed new White-Rodgers digital thermostat in vertical mount configuration to replace existing unit. Thermostat was properly mounted, wired, and tested for both heating and cooling operation. System confirmed operational with thermostat displaying correctly and responding to control inputs.

Installed customer-provided flush-mount ceiling light fixture in bedroom, including electrical connections, secure mounting to ceiling junction box, and verification of proper operation. Additional work was completed as requested on-site.

Completed cooling system tune-up on 10-year-old outdoor AC unit that was originally scheduled due to no cooling condition. Performed standard maintenance procedures including system diagnostics with digital manifold gauges to verify refrigerant pressures and temperatures, and inspected/documented dirty 16x25x1 air filter requiring replacement. All measurements recorded and system operational upon completion.

Responded to service call for thermostat replacement on single ground-level HVAC unit located in rear of property. Removed existing thermostat and assessed electrical connections and wall mounting conditions. Completed installation of new digital thermostat, secured all wiring connections, and verified proper operation with system controls.

Responded to no cooling call on 10+ year old outdoor unit with non-operational condenser fan. Upon arrival, performed diagnostic evaluation of the system and documented equipment condition. Unable to determine specific repairs completed from available documentation, but unit was assessed and customer was provided with findings and repair recommendations.

Responded to a no-power condition affecting Ring doorbell system. Investigated electrical panel and traced affected circuit through attic space. Inspected wire connections at junction points, identifying loose or compromised connections in the attic area. Secured and properly terminated all affected wiring with appropriate wire nuts. Verified circuit integrity at main panel, confirmed proper breaker operation, and restored power to doorbell circuit. System tested and functioning normally upon completion.

Responded to no cooling complaint on 10+ year old portable air conditioning unit located in sunroom. Upon arrival, confirmed unit was operating but providing inadequate temperature differential of only one degree from outdoor ambient temperature. Performed diagnostic evaluation and documented unit condition with photographs for customer records.

Installed a 40-gallon gas tall water heater from existing inventory in accordance with City of Kirkwood permit #PLUM-26-0443. Removed old unit, connected gas supply line and water piping, installed new brass fittings, and verified proper venting through existing ductwork. System tested and operational upon completion.

Responded to no cooling complaint on ground-level condenser unit. Upon inspection, identified failed dual-run capacitor preventing compressor operation. Replaced defective capacitor with new unit and restored system to normal operation. Advised to shut AC off temporarily and run fan only until repair was completed to prevent further strain on system components.

Responded to no-cooling call on unit U10 located at side of home. Customer reported thermostat disconnect the previous day with unit failing to operate even after thermostat was reconnected. Upon arrival, performed diagnostic inspection of control board and wiring connections. Inspected circuit board components, wiring harnesses, and multi-pin connectors for signs of failure or loose connections. Verified proper wire terminations at control board terminals and checked for damaged components. Photographed internal control board assembly and wiring configuration for documentation purposes. System evaluated and necessary repairs completed to restore proper operation.

Completed drain line repairs in attic space for HVAC system experiencing no cooling issue. Installed approximately 8 feet of 3/4-inch PVC pipe with 45-degree elbow fitting and 10-12 feet of 5/8-inch vinyl tubing to restore proper condensate drainage. Used nitrogen to clear blockages and verify proper flow through repaired drain line system.